Due to City batches, the motor shaft of the Ender 3 pro printer may not be perfectly fit for our dual gear. After correct installation, although the gear on the motor shaft looks a little higher than the shaft of the motor, it will not loosen after being. Of course, you can replace the full size of 42mm high stepper motor if the stock motor shaft is too short to Install the gear.
UPGRADE: Perfect replacement for City 3D Printers CR-10/ CR-10S/ CR-10S Pro/ Ender 3/ Tornado, etc.
aluminum alloy, dual gear extrusion, stable and durable.
This Kit NOT include the stepper motor and instruction manual, we need to DIY.

Support: 1.75mm Filament.
Some customers encountered gear wear problems. The solution is:
Had to change the extruder e-steps from 100 to 139
Because the filament is forced to be centered in both drive gear grooves, the idler drive gear (the one not attached to the motor) is positioned on it's shaft by the motor drive dear. So, to center the idler drive gear properly, my suggestion for setting the unit up is as follows:
1. Assemble everything but do not lock the motor drive gear to the shaft.
2. Using a couple pieces of paper, shim the idler drive gear in the center of its bracket.
3. Clamp a piece of filament in the drive grooves and turn the motor a few turns. This should locate the motor drive gear in the correct position.
4. Lock the motor drive gear to the shaft, remove the paper shims, and you should be good to go.
Material:Aluminum alloy
colour:Photo Color

Package Contents:
1 * Dual Gear Extruder